PX4 Chrome Silicon Hammer Spring

PX4 Chrome Silicon Hammer Spring

The Ultimate Reduced Power Hammer Spring for the Beretta PX4 and Beretta 92 Series pistols. This 11lb hammer spring will significantly reduce the DA pull weight and has been hand polished to better allow the spring to smoothly rotate in the hammer spring cup.

FAQ's about the 10# Hammer Spring:

Q: What will my pull-weights be with the 10# Hammer Spring and LTT Trigger Work?

A: Double-Action: 6 to 6.5lbs. (It will likely take 3-4 lbs off the DA over the factory full power spring)

Single-Action: .5lb REDUCTION depending on what trigger work has/has not been done. This will vary based on your firearm and what you have done to it.

Q: Is the 10# Hammer Spring reliable to carry with?

A: The 10# hammer spring has been reliable for us in our testing. All ammunition used was US manufactrued ammunition, as well as some NATO Spec ammo. Please note, reliability may vary with european or non NATO spec ammunition, as well as reloads with tougher primers. With the right ammo, it will be reliable for carry or duty use. We reccomend testing the ammo you would like to carry first before commiting to the lighter spring.  

**If purchasing for the 92, we recommend using the 11# hammer spring for competition only. We do not recommend the 10# hammer spring for the 92/M9/96 series pistols at all**

DISCLAIMER: We recommend that this product as well as all other firearms parts & kits sold by Langdon Tactical be installed by a competent pistolsmith. No liability is expressed or implied for ANY damage or injury which may result from improper installation or use of this product. Installation of any firearm parts may limit or void the manufacturers warranty. We strongly recommend that the safety and operation of your modified handgun be thoroughly checked by an accredited gunsmith prior to use.