Wilson Combat
Magazine Guide w/ NP3 finish ship between 2-4 weeks.
We have found that this product may require some fitting of the lanyard loop pin that holds the guide in place - LTT cannot accept return or replacement for fitment issues.
Not compatible with the 92X.
DISCLAIMER: We recommend that this product as well as all other firearms parts & kits sold by Langdon Tactical be installed by a competent pistolsmith. No liability is expressed or implied for ANY damage or injury which may result from improper installation or use of this product. Installation of any firearm parts may limit or void the manufacturers warranty. We strongly recommend that the safety and operation of your modified handgun be thoroughly checked by an accredited gunsmith prior to use.
25 Reviews Hide Reviews Show Reviews
-
Mag guide
The mag guide is beautiful in np3 finish. I installed this on all my 92s but did noticed that there was a gap between the mag and the frame which is enough to catch the edge of a mag on the frame. Is there any remedy for this issue?
-
Mag Guide
Looks great and super easy installation. Took me longer to find a hex wrench to remove the grips and a punch to push the pin out to remove the stock part than it did to install the new one. The black finish matches my LTT Centurion perfectly and it improves the visual lines of the firearm while also helping guide the magazine during fast reloads.
-
Absolute must!
Fits the factory mag well of the 92x performance perfectly!!!
-
Wilson combat mag guide
The Wilson combat magazine guide is a great upgrade, just like any other magazine guide it does what its meant to do. This one is probably the most low profile and simplest one you can find for the beretta 92 platform. There is a small gap between the mawwell and the mag guide itself but that is by design and it is normal.
-
Two problems to be aware of!
Phenomenal piece of kit that I put in every Beretta I own; fits in the 92x (standard models anyway, idk about the performance models) easy and dramatically speeds up reloads. Two small downsides to be aware of however. One, you cannot run Beretta 30 round 92 mags without modifying the back of the mag sleeve or removing it entirely (do not recommend the latter). Two, on some mags (older Beretta 15 round mags) the base plate on the bottom of those can be just loose enough or just oversized enough that (while it can be inserted fine) the back end of the baseplate can actually slip under the Wilson mag guide. This makes it so the mags will not drop free; you’ll have to push the baseplate forward a bit with your finger and then you can remove the mag. Never had any problems with anything other than the 15 and 30 rounders (have tested all Beretta factory mags and Mecgar mags). The 15 round issue can be solved in about 20 seconds with a handfile; if the backend of your baseplate is a little too big and you’re already sitting on a stack of 15 rounders.
-
Great
This fit great on my 92x with no fitting. Makes mag insertion much easier
-
Great product
This is a must have for all 92’s in my opinion. Little pricey for what it is, but I’ll definitely buy again.
-
Mag guide
Not received LTT Response: Hello, please contact customer service so we can get this to you. We have not been contacted about a missing mag guide.
-
Great for competition or SD!
Like the G model conversion, I got this for my legacy 92 to prep for a competition. Is it worthwhile? Yes! It started as a way of preventing magazines from getting caught on the rear of the magwell (which it does very well). After some practice, it actually became a good index point for faster reloads. If fast magazine changes are important, this is a great upgrade!
Wilson Combat
Wilson Combat "Les Pep" Battlesight Square Notch .305
$49.00
