Beretta grip screws
Fit perfect
A set of 4, 2mm Hex Head Grip Screws for the standard 92 Series guns with 4 washers included. Will not fit Vertec or 92X guns.
DISCLAIMER: We recommend that this product as well as all other firearms parts & kits sold by Langdon Tactical be installed by a competent pistolsmith. No liability is expressed or implied for ANY damage or injury which may result from improper installation or use of this product. Installation of any firearm parts may limit or void the manufacturers warranty. We strongly recommend that the safety and operation of your modified handgun be thoroughly checked by an accredited gunsmith prior to use.
-
-
Very easy to snap them
As another review mentioned, these break very, very easily so be careful installing them. I snapped the first one I tightened using only finger pressure on the end of the Allen key. If one were to use the short end of the Allen key in the screws and try to torque them to spec, they would all undoubtedly snap. Also as mentioned, these are Beretta bits, so it certainly isn’t LT’s fault. I had no issues with mags releasing or binding when installed with the LTT VZ ultra thin grips. The o-rings are perfect for these. I wouldn’t continue using these things if they didn’t look so nice on those black grips. They shore is purty…
-
2mm hex screws np3
These work and look great. Very simple install and fit flush with the ltt thin grips. Simply use the rings that come with the grips if your installing these with the thin grips and not the lock washers.
-
Didn’t work for me
While these screws looked awesome they caused a slight problem on my 92x. Apparently they are a little too long for the stock grips on the 92x and they were causing tough insertion and ejection of magazines.
-
2mm hex screws, black
Be very careful when tightening the hex screws. Beretta made the socket too deep, so there’s very little steel where the shaft meets the flat head. I snapped one off while only using my fingertips to turn the screwdriver. Fortunately I bought 2 sets of screws. They’re Beretta parts, so it’s not LTT’s fault. Also, be aware that there may be interference issues if you’re using thin grips. Make sure your mags insert & drop freely. O-rings definitely help as they take up space. I’ll probably shorten mine with a file so they sit flush with the grip.
-
2mm grip screws
These screws are great they match the np3 parts on my beretta 92fs compact. I really like the o rings hold screws tight. No need for lock tight.
-
New screws for new ultra thin grips
These look so much better than the flat head type that came on my 92FS. The lock washers would not allow a flush seating. Using nothing, the grips were slightly loose. The rubber rings were perfect though. Screws tighten flush and grips are solid.
-
beretta grip screws
factory screws, i changed grips on M9A3, and put on some VZ grips had to use some O rings instead of the washers supplied. fit just fine glad i bought them.
-
2mm Grip Screws
I rarely pay for a good screw, but this one was worth it. :) Another quality product from LTT that shipped very quickly.
- FAQ:
- Beretta 92 FAQ
- Warranty Info:
- Click Here To Read Our Warranty & Return/Exchange Policy
